ClubCJ - The CJ Lancer Club

Hi All
justb got a vrx spoiler to fit onto my ES. I need a copy of the drilling template so i can get the holed lined up. or can i get a template from mitsu ?

The holes are actually already marked on your boot. Just check the underside.

the spoiler has a peg that locates into a third hole on each side. Its a factory spoiler not aftermarket. I would need to esnure the third hole in correct.

cheers

what I would probably do is if the 3rd hole doesnt have a template marking for it, drill out the other 2 holes and using a whiteboard marker, mark the bottom of the peg and then carefully position it where it needs to be.

Otherwise you could just lop it off haha