ClubCJ - The CJ Lancer Club

As the title suggests I'm after a VRX bodykit (front air dams/pods and side skirts). I have a 2010 Lancer SX and I'm wondering if it would fit fine, how hard is it to DIY, and where would be the best place to purchase I found some air dams on eBay but I have not been able to found side skirts, or would I be better off going to the wreckers?

eBay air dams: http://www.ebay.com.au/ulk/itm/161894498464

Thanks in advance.

@ HT_8 ... Your Avatar says Australia ... but which State ?
Both these places are in NSW, so I don't know if they're useful to you

Try this place: Carmate
Here: Front Apron Corners

Location:
766 Woodville Rd, Fairfield East, NSW 2165.

Contact Info:
Email: sales@carmate.com
Phone 1: 02 9723 1111
Phone 2: 02 9723 1110

-------------------------------------------------------------------------------------------


Take a look at this place also:
Fibre Sports

Address - 1 Cawarra Road, Taren Point Sydney NSW 2229
Email - sales@fibresports.com.au
Phone - (02) 4285 9284


Hope this helps, depending on which state you live in.

The wreckers will only sell you the whole bar. I have a complete vrx front if you just want the skirt and spotties.

HT_8 wrote:As the title suggests Im after a VRX bodykit (front air dams/pods and side skirts). I have a 2010 Lancer SX and Im wondering if it would fit fine, how hard is it to DIY, and where would be the best place to purchase I found some air dams on eBay but I have not been able to found side skirts, or would I be better off going to the wreckers? eBay air dams: http://www.ebay.com.au/ulk/itm/161894498464 Thanks in advance.

DIY - Is not too complicated but very time consuming. There are videos for this which I'll link to you when you're ready.

As Sam24A said, Carmate would be okay to go to. Just be aware of their terrible customer service.