ClubCJ - The CJ Lancer Club

TrojanHorse wrote:Busy boy mark! I wish I had time off this arvo to clean my car What do you mean you painted them white? Just the logo, not the whole sidewall I hope!

nar just the Bridgestone potenzas word lol

Went to a 'reputable' tyre place to get my alignment done (I have ongoing issues with car pulling to the left, outside edge of front left tyre worn excessively). They said the wear on the outer edge is too severe it wasn't roadworthy, I can't drive it away in unroadworthy condition, insisted I had to replace it. I had just bought new tyres 6 mths ago, and they won't replace just the one worn tyre, I had to buy a pair at minimum. So flat broke this weekend I'm gutted I don't even feel like driving the thing anymore.

Lesson for all: keep up with your regular wheel alignments and rotations. Every 6 months or whenever you get an oil change, rotate your tyres. If your car develops any alignment issues, attend to it immediately don't let it slide until a time that's convenient for you or it may end up costing you a whole lot more!

BZC-45S wrote:Went to a reputable tyre place to get my alignment done (I have ongoing issues with car pulling to the left, outside edge of front left tyre worn excessively). They said the wear on the outer edge is too severe it wasnt roadworthy, I cant drive it away in unroadworthy condition, insisted I had to replace it. I had just bought new tyres 6 mths ago, and they wont replace just the one worn tyre, I had to buy a pair at minimum. So flat broke this weekend Im gutted I dont even feel like driving the thing anymore. Lesson for all: keep up with your regular wheel alignments and rotations. Every 6 months or whenever you get an oil change, rotate your tyres. If your car develops any alignment issues, attend to it immediately dont let it slide until a time thats convenient for you or it may end up costing you a whole lot more!

that is ridiculous i would have told them to go get stuffed ... but in other words

BZC-45S wrote:Went to a reputable tyre place to get my alignment done (I have ongoing issues with car pulling to the left, outside edge of front left tyre worn excessively). They said the wear on the outer edge is too severe it wasnt roadworthy, I cant drive it away in unroadworthy condition, insisted I had to replace it. I had just bought new tyres 6 mths ago, and they wont replace just the one worn tyre, I had to buy a pair at minimum. So flat broke this weekend Im gutted I dont even feel like driving the thing anymore. Lesson for all: keep up with your regular wheel alignments and rotations. Every 6 months or whenever you get an oil change, rotate your tyres. If your car develops any alignment issues, attend to it immediately dont let it slide until a time thats convenient for you or it may end up costing you a whole lot more!

same. i replaced 2 front 6 months ago, ongoing issuewith car pullling left, just had another alignment. 2 in 2 months coz first time pulled left likea mofo. took it back to adjust, even nowits better but stll pulling a little. is this common on cjs. never had a car with such alignment headache

u need to find a place that will do a good wheel alignment mine was pulling to the left after the wheel alignment i took it back asap and told them to re do it until they got it right !

I finally lowered my car =D
springs still havnt compressed yet so ill post photos in a week or so
30mm drop to remove most of that god awful front wheel gap

Getting my exhaust done. Taking rear muffler and replacing it with a resonator!

I had some courier run up the rear of me ;(

Had final mod installed this morning new Alpine 12inch Type S Sub

Grumpy wrote:Oh no ! Hope youre o.k.... Much damage ?

Pretty bad from what I've seen. Enough to make you strangle the person who hit you ><

Metalstrix wrote:[quote:170af32f1f=Grumpy]Oh no ! Hope youre o.k.... Much damage ?[/quote:170af32f1f] Pretty bad from what Ive seen. Enough to make you strangle the person who hit you ><

I just watch my dash cam video I nearly did strangle him I said f@#k word quite a few times

Started building a wiring loom to fit driving lights to the Evo (provided the light mounting bar I have ordered from USA is good enough.