What's Wrong with that .....
That's how its done at a wheel repair shop .....
OK OK .... they mount the wheel on a Lathe .....
But it can be done ....
If the jack stands are rated & used to support the car correctly.
Due Diligence & Care is taken to Avoid finger/hand entanglement.
The correct gear/wheel speed is selected.
A Bloody huge Fan is used to cool the engine whilst the car is going nowhere.
The correct Buffing Compounds are used in the correct order.
A Jockey is appointed to sit in the car with Foot on Brake & ready to stop at the slightest sound of pain.
The State Ambulance Service is notified / advised to be on Stand-By.
Your closest mates never find out your too tight to pay to have it done.
WorkCover definitely never finds out.
The Roller Door is kept closed so the neighbors don't see it & report you to the local Health & Safety Dept.
But it can be done ......
OK OK ..... maybe too many complicated instructions for the average intelligence found here on CCJ ....
In which Case ........
"Dont Do It" .....