Angel Eyes?

bd-850 · Postby **bd-850** » Tue Feb 08, 2011 10:14 am

i would say yes otherwise how will you get the rings inside the headlight

LZY_EYE · Postby **LZY_EYE** » Tue Feb 08, 2011 10:14 am

You have to bake the headlights to break the seal. You then bake the pieces again to reseal.

Not sure what temperature etc you would use as I have never installed.

PsyTrix · Postby **PsyTrix** » Tue Feb 08, 2011 11:07 am

Id just get it done at concord customs.. Atleast that way you know your getting good quality led rings and they are installed perfectly.

munky88888 · Postby **munky88888** » Tue Feb 08, 2011 1:23 pm

anyone know roughly how much it would cost to get it done at concord customs?

ofey · Postby **ofey** » Tue Feb 08, 2011 2:14 pm

Depends how much liability you will put on them. Say they F**K up the baking? Baking too long and the plastic starts to warp, it will cost them A$300+ to replace that side.

It's great if there's someone out there who can do these things but you must accept that it may not be a perfect job. It's not their car. It's a job.

I strongly suggest this is a DIY thing. It's literally bake till glue softens, put on the rings, clip back the lens melt glue reform seal, put back onto car. Patience is the key. You need a lot of time as you slowly increase the heat till the glue melts.

jerryme · Postby **jerryme** » Mon Feb 14, 2011 5:22 pm

So me and a friend installed my angel eyes today. The kit I bought didn't include instructions so i found the ones by automoglow on this website. The rings weren't as big as the outline of the headlight, so they sit just inside the ring. I went to test the angel eyes and turns out one of the lowbeams had been broken.. So I'm driving with 3 angel eyes

Contacted the seller just before to arrange a replacement. Pics will be up shortly. All in all, it was a success. I would recommend this mod to everyone. It looks great.

jerryme · Postby **jerryme** » Mon Feb 14, 2011 5:54 pm

Some pics

washman · Postby **washman** » Tue Jun 07, 2011 10:21 am

has anyone purchased the automoglow angel eyes, if s o do u guys have any comments on them ?

Glenn · Postby **Glenn** » Tue Jun 07, 2011 10:34 am

Yup. I got mine from automoglow and no issues. Pretty straightforward install although a bit time consuming.

n_aghdassi · Postby **n_aghdassi** » Thu Jun 23, 2011 3:31 am

anyone in perth wanna install mine for a few beers?

13EZY · Postby **13EZY** » Thu Jun 23, 2011 9:17 am

got mine from auto moglow and very happy with the results.
took ages to install - thanks speedy and lancer RA - but read install instructions before purchase, to make sure u know what ur in for

Angel Eyes?

Who is online