As the title suggests I'm after a VRX bodykit (front air dams/pods and side skirts). I have a 2010 Lancer SX and I'm wondering if it would fit fine, how hard is it to DIY, and where would be the best place to purchase I found some air dams on eBay but I have not been able to found side skirts, or would I be better off going to the wreckers?
eBay air dams: http://www.ebay.com.au/ulk/itm/161894498464
Thanks in advance.
***** ALERT - Nominations for your new ClubCJ Committee can be made here *****
VRX Bodykit
Moderators: Moderators, Senior Moderators
@ HT_8 ... Your Avatar says Australia ... but which State ?
Both these places are in NSW, so I don't know if they're useful to you
Try this place: Carmate
Here: Front Apron Corners
Location:
766 Woodville Rd, Fairfield East, NSW 2165.
Contact Info:
Email: sales@carmate.com
Phone 1: 02 9723 1111
Phone 2: 02 9723 1110
-------------------------------------------------------------------------------------------
Take a look at this place also:
Fibre Sports
Address - 1 Cawarra Road, Taren Point Sydney NSW 2229
Email - sales@fibresports.com.au
Phone - (02) 4285 9284
Hope this helps, depending on which state you live in.
Both these places are in NSW, so I don't know if they're useful to you
Try this place: Carmate
Here: Front Apron Corners
Location:
766 Woodville Rd, Fairfield East, NSW 2165.
Contact Info:
Email: sales@carmate.com
Phone 1: 02 9723 1111
Phone 2: 02 9723 1110
-------------------------------------------------------------------------------------------
Take a look at this place also:
Fibre Sports
Address - 1 Cawarra Road, Taren Point Sydney NSW 2229
Email - sales@fibresports.com.au
Phone - (02) 4285 9284
Hope this helps, depending on which state you live in.
Last edited by SAM-24A on Sat Dec 12, 2015 7:52 am, edited 1 time in total.
Sam .....
Merlinised MIVEC - AspiRe 2.4L
Merlinised MIVEC - AspiRe 2.4L
- Metalstrix
- Post Monster
- Posts: 2739
- Joined: Thu Dec 13, 2012 4:16 pm
- Location: Sydney Australia
HT_8 wrote:As the title suggests Im after a VRX bodykit (front air dams/pods and side skirts). I have a 2010 Lancer SX and Im wondering if it would fit fine, how hard is it to DIY, and where would be the best place to purchase I found some air dams on eBay but I have not been able to found side skirts, or would I be better off going to the wreckers? eBay air dams: http://www.ebay.com.au/ulk/itm/161894498464 Thanks in advance.
DIY - Is not too complicated but very time consuming. There are videos for this which I'll link to you when you're ready.
As Sam24A said, Carmate would be okay to go to. Just be aware of their terrible customer service.
They will learn... I will always be a step ahead
No longer an active member.
No longer an active member.
Who is online
Users browsing this forum: No registered users and 9 guests